Gibson Truss Rod Channel

How to carve a neck pocket how to make a magnetic truss rod cover a new way to make a humbucker pickup routing template how to install a truss rod and.

Gibson truss rod channel.

On a newer guitar adjusting the truss rod isn t particularly daunting as long as you have some idea what you re doing. One design is the rod from allied lutherie above and also lmi though they are slightly different the overall design is close to the same. It consists of a long round piece of 3 8 approx steel with an anchor on one end and a nut on the other. As they are tightened the push against the center of the curve forcing the neck backwards.

The nut is used to tighten the rod and straighten the neck. These will be the ends of the channel. Now you re ready to start adjusting. Once the position of the neck is set with the bolts the nut can be tightened to prevent the bolt from turning.

The latest version from allied lutherie is really beautiful and very high quality. T nuts to hold the bolts on the truss rod channel routing jig. Gibson truss rod brass nut brass nut on gibson les paul adjust nut with correct spanner loosen first. Always loosen the truss rod nut first as if it is stuck and you over tighten it then you could damage the guitar.

Check relief at 12th fret using steel rule or feeler gauge. Create the truss rod channel. A quick review of an alternative bit you can use to route the truss rod channel for the stewmac hotrod truss rods amazon link. The first is a vintage truss rod originally designed by gibson.

The other kind of rod is a dual action truss rod that consists of two round pieces of steel attached at both ends. Old truss rods can be trouble because the nut can rust or otherwise get stuck. When the truss rod is in the correct position make two pencil marks on the neck representing the front and back of the truss rod. Exerting too much force to loosen it can bust the rod or strip the nut.

There are two rods that i like very much. Single acting truss rods as used by gibson and fender sit in a curved channel inside the neck. The double action two way truss rod is my preference.